How To Set Up Bobbin On Brother Sewing Machine

How do I wind the bobbin?

Merely apply the bobbin that comes with this car or bobbins of the same type (role lawmaking: SA156, SFB: XA5539-151). Using other bobbins may cause damage to the motorcar.
We designed the bobbin that comes with this machine. If you utilise bobbins from other models, the motorcar volition not work properly.

(ane) This model (2) Other models
(3) 11.v mm (7/16 inch)

Pull upwards the spool pivot completely.
Put a spool of thread on this pivot.

If the spool of thread is in the incorrect place, or is set incorrectly, the thread may tangle on the spool pivot.
While holding the thread from the spool with your right hand, pass the thread toward you, in the groove on the thread guide. So, pass the thread around the pre-tension disk and pull the thread in completely.

(A) Pre-tension disk (B) Pull the thread completely

Make sure that the thread passes under the pre-tension disk.
Laissez passer the end of the thread through the hole on the bobbin from the inside of the bobbin.
Put the bobbin onto the bobbin winder shaft and slide the bobbin winder shaft to the correct. Turn the bobbin clockwise, by hand, until the project slides into the notch of the bobbin.

(i) Projection
(2) Notch
* Align the notch of the bobbin to the projection on the shaft.
(iii) 7 - x cm (three to iv inches)

Make certain to pull out 7 to 10 cm (3 to 4 inches) of thread from the hole on the bobbin.

Pull the thread taut and concur the end of the thread direct upward. If the thread is too short, not pulled taut or held at an angle, injuries may occur when the thread is wound effectually the bobbin.
Plow on the machine.

Do not turn on the automobile while pressing down the foot controller. The motorcar may kickoff unexpectedly and crusade personal injury or harm to the motorcar.
While holding the end of the thread, gently press the foot controller to wind the thread around the bobbin a few times. And so stop the auto.

(1) 7 - 10 cm (2-3/four to three-fifteen/xvi inches)
Trim the excess thread above the bobbin.

(1) Go out 1 cm (1/2 inch) of thread from the hole on the bobbin.

Make sure y'all follow the instructions carefully. If you do not cut the excess thread completely before winding the bobbin, when the thread runs low information technology may tangle effectually the bobbin and crusade the needle to pause.
Press the foot controller to start.
When the bobbin seems full and begins spinning slowly, take your foot off the pes controller.
Cut the thread, slide the bobbin winder shaft to the left and remove the bobbin.
- When the sewing machine is started or the handwheel is turned after winding the thread effectually the bobbin, the machine volition make a clicking sound; this is not a malfunction.
- The needle bar does not motion when you lot slide the bobbin winder shaft to the right.